Select "print" from your browser's "File" menu.

Back to Post
Username Post: Drawings
Todd Wallace
Administrator
Posts 258
Todd Wallace
01-02-13 10:57 AM - Post#657    

Here are 2 different drawings with 2 different drops

Attached are the files you requested regarding the mustang motor mounts that mimic the Ron Morris ones. FYI, the CAD file has different plates shown above, which were previous runs of these mounts that had different top plates for each mount. The PDFs were established so you didn't have unique top plates for each side, making things a bit easier although it takes a little more steel. There is also a random drawing in there of my T56 trans crossmember. As stated before, the PDF is printable to scale on 8.5x11 paper. Be sure to measure the scale that I included in the plot to verify that it printed to scale. The 1.0 should measure exactly an inch. The bushings to use with these mounts are the same for the rear leaf spring shackles, so you can buy either Poly or rubber bushings.



Attachment: Motor_Mounts_0.5in_Drop_Height.pdf (22.31 KB) 2563 Views
Attachment: Motor_Mounts_1in_Drop_Height.pdf (22.32 KB) 2536 Views
Attachment: _All_3.dwg (230.72 KB) 2609 Views
Attachment: _standard_height.pdf (21.72 KB) 2677 Views
Attachment: Motor_Mounts.dxf (610.58 KB) 2698 Views


FusionBB™ Version 3.0 RC2 | ©2003-2010 InteractivePHP, Inc.
Execution time: 0.084 seconds.   Total Queries: 17   Zlib Compression is on.
All times are (GMT -0600) Central. Current time is 04:33 PM
Top